| Connectors
|
E1: (2) 75 ohm
coax; (1) duplex or simplex fiber optic
T1/E1: (1) UTP 100/120 ohm RJ-45;
(1) duplex or simplex fiber optic |
|
Fiber Optic Connector Specs |
| Multimode |
Min TX PWR: -19.0 dBm
Max TX PWR: -14.0 dBm
RX Sensitivity: -32.5 dBm
Max In PWR: -14.0 dBm
Link Budget: 13.50 dB |
| Switches
|
SW1: 1,2,3: Line
Build out for short haul/DB in Long Haul (See
Table)
Short Haul Mode:
SW1: Pos 4 not used
SW2 - 1:Transmit all ones into
copper on loss of fiber link (Up=Disabled)
SW2 - 2:Transmit all ones (AIS)
into fiber on loss of copper link (Up=Disabled)
SW2 - 3: Long Haul/Short Haul
(Up=Short Haul)
SW2 - 4: T1/E1 selection (Up=T1) |
| 3-position
Jumper |
Hardware:
Converter mode is determined by 4-position switch settings
Software: Converter mode is determined by most recently
saved on-board microprocessor settings. |
| Status LEDs
|
PWR (Power):
Steady green LED indicates connection to external AC power
SDC (Signal Detect/Copper): On indicates twisted pair
link is up
SDF (Signal Detect/Fiber): On indicates fiber link is up
|
| Dimensions
|
Width: 3.25" (82 mm)
Depth: 4.8" (122 mm)
Height: 1.0" (25 mm) |
| Power
|
External AC/DC
required; 12V DC; .5A; unregulated; standard |
| Environment
|
0 – 50°C operating;
5 – 95% humidity non-condensing;
0 – 10,000 feet altitude |
| Safety
Compliance |
Wall Mount Power Supply:
UL listed and CSA certified |
| Regulatory
Compliance |
FCC Class A, CISPR/EN55022
Class A, CE Mark |